-Input Voltage:  4-12V

-Low Voltage Protection:  6.2V (Li-Po)

-Max. Current:  10 Amp

-Operating temperature:  0-50 Celsius degree

-Battery Mode:  Ni-MH / Ni-Cd Battery; Li-Po Battery

-Weight:  ≤7g

-User Manual included

Features:

-SKYRC introduces the POWER SWITCH, a tiny MCU controlled on/off switch for your radio controlled model.

-A simple push button operates the switch meaning to eliminate the problems associated with intermittent contact of an ordinary mechanical switch.

-The sealed unit is plastic and can easily be mounted to the transponder mount of your model or anywhere else you can mount it by using double side tape (Two kinds of bottom covers are included, and user can change the bottom cover).

-The switch also features a Li-Po mode, by turning this on the switch unit will it automatically detect low Li-Po voltage and cut off power to protect your Li-Po from over discharging. This of course can be turn off if you have other safeguards in place or using Ni-MH/Ni-Cd battery.

-Beside that the power switch informs you about the remaining capacity and conditions of your battery pack.

Warranty and Service: 

-We guarantee this product to be free of manufacturing and assembly defects for a period of one year from the time of purchase.

-The warranty only applies to material or operational defects, which are present at the time of purchase. During that period, we will repair or replace free of service charge for products deemed defective due to those causes.

-You will be required to produce proof of purchase (invoice or receipt).

-This warranty is not valid for any damage or subsequent damage arising as a result of misuse, modification or as a result of failure to observe the procedures outlined in this manual.

Switch On/Off Set up

1. NiMH/NiCad Battery Pack

For switching on please press and hold the button for one second. The PWR LED will turn on. For switching off please press and hold the button until all LEDs turn off. The PWR LED also shows you the remaining battery capacity when switched on.

2. LiPo Battery Pack

For switching on please press and hold the button for more than three second. The PWR LED and LIPO LED will turn on. For switching off please press and hold the button until all LEDs turn off. The PWR LED also shows you the remaining battery capacity when switched on.